Skip to main content
DFA Carpentry logo

Cape Cod Window and Door Replacement That Seals Out Drafts and Storms

Replacement windows, entry doors and patio doors installed with the flashing and sealing a coastal house needs, inside and out.

  • 5 years of hands-on experience
  • Permits handled by the owner

Or call (732) 859-9559

Get a Free Estimate

Instant confirmation, no spam. We only use your info to send your estimate.

  • CSL #124008
  • HIC #654419
  • Licensed & Insured
  • Free estimates

Windows & Doors on Cape Cod, Done Right

Old windows and doors are where a Cape house loses heat in January and lets in water when a storm blows sideways. Replacing them is one of the most noticeable upgrades you can make, but only if the installation is done right. Daniel replaces windows, entry doors, storm doors and sliding or swinging patio doors, and the work is less about the unit and more about the opening around it. That means checking the sill and framing for rot, flashing the opening so water is directed out instead of in, insulating and sealing the gaps, and finishing the trim so it looks like it belongs on the house. For doors that open onto a deck, he makes sure the threshold and deck height work together. If your home sits in a local historic district, window and door changes visible from the street may need approval, and Daniel will tell you what to expect. You get a clear scope and price at a free on-site estimate.

The opening matters more than the window

Rotted sills repaired, every opening flashed and sealed, trim finished to match the house. That is what makes a new window actually stop the draft.

How it works

Our Windows & Doors Process

01

Free on-site estimate

Daniel checks each opening for rot, drafts and water stains, measures, and talks through window and door styles with you.

02

Order and permit

You confirm the units and scope in writing. Daniel handles the permit and any historic district paperwork with your town.

03

Remove, repair and flash

Old units come out one opening at a time, damaged framing is repaired, and the opening is flashed before the new unit goes in.

04

Install, seal and trim

New windows or doors are set, insulated, sealed and trimmed, hardware is adjusted, and the house is cleaned up.

Why Cape Cod Homeowners Choose DFA Carpentry for Windows & Doors

  • Daniel handles every permit himself

    Drawings, the application, and every inspection with the town building department. You never chase paperwork.

  • Licensed in Massachusetts

    Construction Supervisor License CSL #124008 (Unrestricted) and Home Improvement Contractor HIC #654419. Licensed, insured and OSHA certified.

  • Built to the Massachusetts State Building Code

    Footings, framing, fastening and railings are done the way the code and the inspector expect, not the way that is fastest.

  • Straight answers, on time

    Clear communication, showing up when we said we would, and doing what we said we would do. If something is not a good idea, Daniel tells you.

Windows & Doors: Frequently Asked Questions

Replacement windows fit into the existing frame and are less invasive when the frame is in good shape. New construction windows replace the whole unit down to the framing and make sense when there is rot, when siding is also being replaced, or when the opening size is changing. Daniel looks at your openings and recommends the right approach for each.
Usually, yes, especially when replacing old single-pane or leaky windows. A big part of the difference comes from how well the opening is insulated and sealed during installation, not just the glass. Results vary with the house, so we do not promise a specific savings number.
Yes. Patio and sliding doors onto decks are a common job. Daniel checks the threshold height, the framing under the door and how the deck meets the house, because water at that connection is a frequent source of rot. If you are planning a new deck too, doing both together often makes sense.
In Massachusetts, many window and door replacements need a building permit, and homes in historic districts may need additional approval for changes visible from the street. Daniel checks your address and handles the paperwork himself.
Ordering units is often the longest wait, and lead times change by brand and season. Once they arrive, a typical house is usually done in a few days, one opening at a time, so the home is never left open overnight. Daniel gives you a realistic schedule at the estimate.

Get a Free On-Site Estimate for Your Windows & Doors Project

Daniel comes out, looks at the job, and gives you a straight answer and a written scope. No pressure.